NOX Sensor 1/2

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing NOx Sensor Module

Courtesy of CHRYSLER GROUP, LLC

Disconnect both negative battery cables.
Disconnect the NOx sensor module harness connector (3).
Remove nuts (1) and the NOx module (2).

Fig 2: Removing/Installing NOx Sensor
Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness retainers.
Remove the NOx sensor 1/2 (1) from the Selective Catalytic Reduction (SCR) catalyst (2).