LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Engine Cooling System - 2500 Hd & 3500 Hd) >> Transmission >> Cooler, Transmission Oil >> Installation >> Gas >> External Transmission Cooler

External Transmission Cooler

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Transmission Oil Cooler
GC0083420Courtesy of CHRYSLER GROUP, LLC
  1. Position the transmission cooler tubes to the front of the radiator by sliding brackets into slots on radiator inlet tank.
  2. Snap the transmission cooler tubes into the clips on the side of the radiator tank.
  3. Install the transmission cooler attaching bolt. Tighten the bolt to 16 N.m (140 in. lbs.).
  4. Inspect the quick connect fittings for debris and install the quick connect fitting on the cooler tube until an audible "click" is heard. Pull on the connection to verify proper installation and install the secondary latches. Refer to TUBES AND HOSES, TRANSMISSION OIL COOLER, STANDARD PROCEDURE .
  5. Start the engine and check all fittings for leaks.
  6. Check the fluid level in the automatic transmission.
scientia non olet · About LEMON Manuals