Sensor, Coolant Temperature: Removal: 5.7L
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Viscous fan, fan shroud and electric cooling fan removed for clarity.
- Partially drain the cooling system. Refer to STANDARD PROCEDURE .WARNING:
Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the engine coolant temperature (ECT) sensor.
- Disconnect the electrical connector from the engine coolant temperature (ECT) sensor (2).
- Remove the engine coolant temperature (ECT) sensor (2) from the water pump assembly.