LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Engine Cooling System - 2500 Hd & 3500 Hd) >> Engine >> Sensor, Coolant Temperature >> Installation >> 6.7L Diesel

6.7L Diesel

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Engine Coolant Temperature Sensor (6.7L Diesel)
GC0155244Courtesy of CHRYSLER GROUP, LLC
  1. Install the Engine Coolant Temperature (ECT) sensor (1). Tighten sensor (2) to 18 N.m (159 in. lbs.).
    Fig 2: ECT Sensor Wire Harness Connector
    GC0155284Courtesy of CHRYSLER GROUP, LLC
  2. Connect the ECT sensor wire harness connector (1).
    Fig 3: ECT Sensor Shield & Bolts
    GC0155347Courtesy of CHRYSLER GROUP, LLC
  3. Install the heat shield (2). Tighten bolts (1) to 9 N.m (97 in. lbs.).
  4. Install the upper EGR tube (1). Refer to TUBE, EXHAUST GAS RECIRCULATION (EGR), CROSSOVER, INSTALLATION .
  5. Fill the cooling system. Refer to STANDARD PROCEDURE .
    Fig 4: Engine Cover, Bolts & Oil Dipstick
    GC0155408Courtesy of CHRYSLER GROUP, LLC
  6. Install the engine cover (2) and fasteners (1, 4).
  7. Install the engine oil dip stick (3).
  8. Connect both negative battery cables.
scientia non olet · About LEMON Manuals