LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Engine Cooling System - 2500 Hd & 3500 Hd) >> Engine >> Pump, Water >> Removal >> 5.7L

Pump, Water: Removal: 5.7L

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Thermostat Housing, Water Pump, Belt Tensioner, & Idler Pulley
GC0137090Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect negative battery cable.
  2. Remove the air intake assembly. Refer to BODY, AIR CLEANER, REMOVAL, 5.7L GAS or BODY, AIR CLEANER, REMOVAL, 5.7L CNG .
  3. Remove the resonator mounting bracket.
  4. Remove cooling fan assembly. Refer to FAN, COOLING, ELECTRIC, REMOVAL  and FAN, COOLING, VISCOUS, REMOVAL .
  5. Drain coolant into a clean container. Refer to STANDARD PROCEDURE .
  6. Remove the upper radiator hose from the thermostat housing (1) and position aside.
  7. Remove serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
  8. Remove idler pulley (5).
  9. Remove belt tensioner assembly (4). Refer to TENSIONER, BELT, REMOVAL .
  10. Remove lower radiator hose from the water pump and position aside.
  11. Remove the upper metal heater tube from the cylinder head.
  12. Remove water pump mounting bolts (6) and remove pump (3).
scientia non olet · About LEMON Manuals