LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Engine Cooling System - 2500 Hd & 3500 Hd) >> Accessory Drive >> Belt, Serpentine >> Diagnosis And Testing >> Diagnosis And Testing - Serpentine Belt >> Visual Diagnosis

Visual Diagnosis

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Diesel Engine: If a belt is broken or frayed, inspect the engine speed sensor (located near crankshaft damper) for damage.

When diagnosing serpentine accessory drive belts, small cracks that run across the ribbed surface of the belt from rib to rib, are considered normal. These are not a reason to replace the belt. However, cracks running along a rib (not across) are not  normal. Any belt with cracks running along a rib must be replaced. Also replace the belt if it has excessive wear, frayed cords or severe glazing.

Refer to ACCESSORY DRIVE BELT DIAGNOSIS CHART  for further belt diagnosis.