Valve, Oil Pressure Relief: Removal: Removal
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect both negative battery cables.
- Remove the threaded plug (2), spring (4).
- Insert a finger or a seal pick to lift the plunger (5) from the bore.
NOTE:
If the plunger is stuck in the bore, it will be necessary to remove the filter head. Also, the pressure relief valve (not shown in the illustration) is located behind filter head.