LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 351 (6.7L Engine (Service Information) - 2500 Hd & 3500 Hd) >> Lubrication >> Diagnosis And Testing >> Diagnosis And Testing - Engine Oil Pressure

Diagnosis And Testing - Engine Oil Pressure

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 1/8 NPT plug from the top of the oil filter housing.
  2. Install Oil Pressure Line and Gauge Tool (special tool #C-3292A, Gauge, Pressure) with a suitable adapter.
  3. Start engine and warm to operating temperature.
  4. Record engine oil pressure and compare with engine oil pressure chart.
    CAUTION:

    If engine oil pressure is zero at idle, DO NOT RUN THE ENGINE.

    Engine Oil Pressure (MIN)
    At Idle 68.9 kPa (10 psi)
    At 2500 RPM 206.9 kPa (30 psi)

    If minimum engine oil pressure is below these ranges. Refer to DIAGNOSIS AND TESTING  .

  5. Remove oil pressure gauge and install the 1/8 NPT plug.
scientia non olet · About LEMON Manuals