Cylinder Head Cover

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover, Bolts & Oil Dipstick

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate both negative battery cables.
Remove the engine oil dipstick (3).
Remove fasteners (1, 4) and the engine cover (2).

Fig 2: Locating Crankcase Pressure Sensor
Courtesy of CHRYSLER GROUP, LLC
Disconnect the crankcase pressure sensor 1 wire harness connector (7).

Fig 3: Crankcase Pressure Sensor Wire Harness Connector & Clamp
Courtesy of CHRYSLER GROUP, LLC
Disconnect the crankcase pressure sensor 2 wire harness connector (1).

Fig 4: Cylinder Head Cover Components
Courtesy of CHRYSLER GROUP, LLC
Remove the Close Crankcase Ventilation (CCV) cover (4) and crankcase breather. Refer to SYSTEM, CLOSED CRANKCASE VENTILATION (CCV), REMOVAL .
Remove the two CCV oil drains tubes (3) from cylinder head cover (4).

Fig 5: Cylinder Head Cover & Gasket
Courtesy of CHRYSLER GROUP, LLC
Remove bolts (1) and the cylinder head cover (2).

Fig 6: Injector Harness Connectors
Courtesy of CHRYSLER GROUP, LLC
If necessary, disconnect both injector harness connectors (1).

Fig 7: Injector Harness Nuts, Cylinder Head Cover/Injector Wiring Gasket & Injector Wiring Harness Connectors
Courtesy of CHRYSLER GROUP, LLC
If necessary, loosen the fuel injector wire harness nuts (1) on the cylinder head cover gasket (2).
If necessary, remove the cylinder head cover gasket (2).