Cylinder Head Cover

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Injector Harness Nuts, Cylinder Head Cover/Injector Wiring Gasket & Injector Wiring Harness Connectors

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Gasket must be completely dry and free of oil before installation. Pneumatic tools should NOT be used to remove or install the cover.

Clean all the gasket sealing surfaces. Refer to ENGINE GASKET SURFACE PREPARATION .
Inspect cylinder head cover gasket (2) for tears, or splits. Replace if necessary.
If removed, install the cylinder head cover gasket (2) on the rocker box. Tighten the fuel injector wire harness nuts (1) to 1.50 N.m (13 in. lbs.).

Fig 2: Injector Harness Connectors
Courtesy of CHRYSLER GROUP, LLC
If removed, connect both fuel injector wire harness connectors (1).

Fig 3: Cylinder Head Cover & Gasket
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Pneumatic tools should NOT be used to remove or install the cover.
Install the cylinder head cover (2). Tighten bolts (1) from the center out to 24 N.m (18 ft. lbs.).

Fig 4: Cylinder Head Cover Components
Courtesy of CHRYSLER GROUP, LLC
Install the Close Crankcase Ventilation (CCV) drain tubes (3) to the cylinder head cover (4).
Install the crankcase breather and CCV cover (4). Refer to SYSTEM, CLOSED CRANKCASE VENTILATION (CCV), INSTALLATION .

Fig 5: Crankcase Pressure Sensor Wire Harness Connector & Clamp
Courtesy of CHRYSLER GROUP, LLC
Connect the crankcase pressure sensor 2 wire harness connector (1).

Fig 6: Locating Crankcase Pressure Sensor
Courtesy of CHRYSLER GROUP, LLC
Connect the crankcase pressure sensor 1 wire harness connector (7).

Fig 7: Engine Cover, Bolts & Oil Dipstick
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover (2) and fasteners (1, 4).
Install the engine oil dipstick.
Connect both negative battery cables.
Start the vehicle and check for leaks.