Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT DRIVER DOOR SWITCH ASSEMBLY FOR DAMAGE
NOTE:
Diagnose and repair all LIN Bus related Diagnostic Trouble Codes (DTCs) before performing this test procedure.
1. Turn the ignition off.
2. Inspect the Driver Door switch assembly for damage.
  Is the switch assembly damaged?
  
  Yes
  - Replace the Driver Door switch assembly in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
  No
  - Go To 2.
INSPECT FOR OBJECT OR SUBSTANCE CAUSING RIGHT MIRROR SELECT SWITCH TO STAY OR STICK IN A PUSHED POSITION
1. Inspect the Right Mirror Select switch for anything that would cause it to stay or stick in a pushed position.
  Is anything present that would cause the Right Mirror Select switch to stay or stick in a pushed position?
  
  Yes
  - Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
  No
  - Go To 3.
TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. Using a scan tool, record and erase DTCs.
3. Press and release the Right Mirror Select switch several times and then wait 30 seconds.
4. Using a scan tool, read DTCs.
  Is the same DTC active?
  
  Yes
  - Replace the Driver Door switch assembly in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
  No
  - The conditions that caused this code to set are not present at this time.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .