LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 ((Driver Door Module (DDM) (DMFL) - Electrical Diagnostics)) >> Diagnosis and Testing >> B1D00-2A-Mirror Fold Switch Input Stuck >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. VERIFY IF DTC B1D00-2A MIRROR FOLD SWITCH INPUT STUCK IS ACTIVE 
    1. Turn the ignition on.
    2. With the scan tool, erase the DTCs.
    3. Press the Mirror Fold Switch in both directions several times.
    4. Cycle the ignition from on to off three times.
    5. Turn the ignition on.
    6. With the scan tool, read the active DTCs.

      Does the scan tool display active: B1D00-2A MIRROR FOLD SWITCH INPUT STUCK?

      Yes 

      • Replace the Drivers Door Window/Mirror Switch Assembly in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .

      No 

      • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and poor pin fit. Repair as necessary.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
scientia non olet · About LEMON Manuals