Cover, Engine: Removal: Removal

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover, Clean Air Hose, Intake Air Temperature (IAT) Sensor Electrical Connector & Air Cleaner Housing

Courtesy of CHRYSLER GROUP, LLC

Disconnect the IAT sensor electrical connector (3).
Remove the clean air tube (2) from the air cleaner housing (4) and the throttle body.

Fig 2: Engine Cover & Grommets
Courtesy of CHRYSLER GROUP, LLC
Lift up the front of the engine cover (1) and separate the engine cover front grommets (2) from the ball studs on the intake manifold.

Fig 3: Engine Cover Pegs & Grommets
Courtesy of CHRYSLER GROUP, LLC
Slightly raise the front of the engine cover and slide forward to remove the rear engine cover pegs (2) from the grommets (1) on the rear of the intake manifold.

Fig 4: Engine Cover, Clean Air Hose, Intake Air Temperature (IAT) Sensor Electrical Connector & Air Cleaner Housing
Courtesy of CHRYSLER GROUP, LLC
Remove the engine cover (1).