6.7L Diesel Engine
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions may result in serious or fatal injury. Refer to WARNING and CAUTION .
NOTE:
A/C condenser for manual transmission model shown in illustration. Shown with front fascia removed for clarity. Automatic transmission model similar.
- Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
- Remove the front bumper. Refer to BUMPER, FRONT, REMOVAL .
- If necessary, detach the hood cable from hood latch and retainers clips (2).
- If necessary, remove push pins (3) and air deflector (1).
- If equipped, disconnect the automatic transmission cooler lines from the transmission fluid cooler fittings located at each end of the A/C condenser (1). Refer to TUBES AND HOSES, TRANSMISSION OIL COOLER, STANDARD PROCEDURE .
- Remove the bolts (6 and 8) that secure the A/C liquid line (5) and the A/C discharge line (9) from the A/C condenser.
- Disconnect the A/C liquid and discharge lines from the A/C condenser and remove and discard the O-ring seals and gaskets.
- Install plugs in, or tape over the opened refrigerant line fittings and condenser ports.
- Remove the four bolts (2, 7 and 10) that secure the A/C condenser to the charge air cooler.
- Remove the A/C condenser from the engine compartment.
- If required, remove the four bolts (4) that secure the four retaining brackets (3) to the A/C condenser and remove the brackets. Replace the rubber isolators if necessary.