Air Inlet Housing

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Of The Air Inlet Housing

Courtesy of CHRYSLER GROUP, LLC

NOTE:

If the foam seal on the air inlet housing is deformed or damaged, it must be replaced.

Position the air inlet housing (1) onto the top of the HVAC housing (2).
Engage the two retaining tabs (3) that secure the front of the air inlet housing to the HVAC housing.

Fig 2: Air Inlet Housing
Courtesy of CHRYSLER GROUP, LLC
Engage the two retaining tabs (4) that secure the rear of the air inlet housing (3) to the HVAC housing (5).
Connect the HVAC wire harness (1) to the recirculation door actuator (2).
Install the HVAC housing assembly. Refer to HOUSING, HVAC, INSTALLATION .