Shaft, Axle: Installation: Installation
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Axle flange bolts must be replaced or cleaned existing bolts apply Mopar™ Lock N' Seal or Loctite® 242 on the threads.
- Clean axle flange and hub.
- Install new axle shaft gasket.
- Slide axle shaft into the axle tube.
- Install axle shaft flange (1) bolts (2) and tighten to 129 N.m (95 ft. lbs.).