Diagnosis And Testing - Rear Axle - 10 1/2 Aa: Vibration

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Vibration at the rear of the vehicle is usually caused by:

Damaged drive shaft.
Missing drive shaft balance weight(s).
Worn or out-of-balance wheels.
Loose wheel lug nuts.
Worn U-joint(s).
Loose/broken springs.
Damaged axle shaft bearing(s).
Loose pinion gear nut.
Excessive pinion yoke run out.
Bent axle shaft(s).

Check for loose or damaged front-end components or engine/transmission mounts. These components can contribute to what appears to be a rear end vibration. Do not overlook engine accessories, brackets and drive belts.

NOTE:

All driveline components should be examined before starting any repair.