Repair Procedure For CHMSL (3RD Brake Light)

Parts Required:

• Mopar Glass Sealer

Fig 1: Center High Mounted Stop Lamp Assembly

Courtesy of CHRYSLER GROUP, LLC

1. Remove the CHMSL (Center High Mounted Stop Lamp) assembly. Refer to LAMP, CENTER HIGH MOUNTED STOP, REMOVAL .
   Fig 2: Identifying Bead Of Heavy Bodied Sealer

   Courtesy of CHRYSLER GROUP, LLC
2. Apply 1/8 inch bead of Heavy Bodied Sealer (3) around the lamp (1) on the foam gasket material (2), leaving no gaps.
3. Install the CHMSL assembly. Refer to LAMP, CENTER HIGH MOUNTED STOP, INSTALLATION .
4. Remove any excess sealer that squeezes out onto the painted surface or exterior lamp assembly.