LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 341 (Tires & Wheels (Service Information) 2500 Hd & 3500 Hd) >> Wheels >> Stud, Wheel >> Installation >> Rear - 1500 Only

Rear - 1500 Only

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Wheel Mounting Stud Installation
GC0082305Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Move axle shaft carefully to prevent damage to the shaft bearing and seal in the axle tube.

  1. Install the new stud (4) into the back of the hub flange (2) and seat as follows:
    1. Install three proper sized washers (1) onto the new stud (4), then install a lug nut (3) with the flat side of the nut against the washers.
    2. Tighten the lug nut (3) until the stud (4) is pulled into the hub flange (2). Verify that the stud is properly seated into the flange.
    3. Remove the lug nut (3) and washers (1).
  2. Install the axle shaft, refer to the appropriate REAR AXLE article.
  3. Using a new lug nut on the new stud, install the wheel and tire assembly. Refer to WHEELS, STANDARD PROCEDURE .
  4. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals