LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 340 (Antilock Brake System (Abs) (Service Information) 2500 Hd & 3500 Hd) >> Electrical >> Sensor, Wheel Speed, Rear >> Removal >> 1500/2500/3500

Sensor, Wheel Speed, Rear: Removal: 1500/2500/3500

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

All views typical.

Fig 1: Identifying Wheel Speed Sensor, Bolt, Adapter, And Electrical Connector
GC0083404Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Disconnect the wheel speed sensor electrical connector (3).
  3. Remove the mounting bolt (1) from the sensor (4).
  4. Remove the sensor (4) from the brake caliper adapter.
scientia non olet · About LEMON Manuals