LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Base Brakes (Service Information) - 2500 Hd & 3500 Hd) >> Parking Brake >> Cable, Parking Brake >> Removal >> Rear Park Brake Cable

Rear Park Brake Cable

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Lock Out Parking Cable
GC0091775Courtesy of CHRYSLER GROUP, LLC
1 - LOCKING PLIERS
2 - PARKING BRAKE CABLE
  1. Raise and support the vehicle.
  2. Lockout the parking brake cable (2).
    Fig 2: Lever & Cable End
    GC0091776Courtesy of CHRYSLER GROUP, LLC
    1 - LEVER
    2 - CABLE END
  3. Loosen cable adjuster nut.
  4. Remove the rear park brake cable from the intermediate park brake cable.
  5. Compress tabs on cable end fitting on the rear park brake cable to the frame mount bracket. Then pull the cable through the bracket.
  6. Disengage the park brake cable (2) from behind the rotor assembly.
  7. Compress cable tabs on each cable end fitting at the brake cable support plate.
  8. Remove the cables from the brake cable support plates.
scientia non olet · About LEMON Manuals