Front Parking Brake Cable

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lock Out Parking Cable

Courtesy of CHRYSLER GROUP, LLC

1 - LOCKING PLIERS

2 - PARKING BRAKE CABLE

Raise and support vehicle.
Lockout the parking brake cable (2)
Loosen adjusting nut to create slack in front cable.
Remove the front cable from the cable connector.
Compress cable end fitting at underbody bracket and remove the cable from the bracket.
Lower vehicle.
Push ball end of cable out of pedal clevis with small screwdriver.

Fig 2: Parking Brake Pedal & Cable
Courtesy of CHRYSLER GROUP, LLC

1 - PARK BRAKE PEDAL

2 - FRONT CABLE
Compress cable end fitting at the pedal bracket (1) and remove the cable (2)
Remove the left cowl trim and sill plate.
Pull up the carpet and remove the cable from the body clip.
Pull up on the cable and remove the cable with the body grommet.