Rear Park Brake Cable

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lever & Cable End

Courtesy of CHRYSLER GROUP, LLC

1 - LEVER

2 - CABLE END

Push each cable end (2) through the brake cable support plate hole until the cable end fitting tabs lock into place.
NOTE:
Pull on the cable to ensure it is locked into place.
Push the cable through the frame bracket.
Lock the left cable end fitting tabs into the frame bracket hole.
Install the rear cables into the tensioner rod behind the rear of the brake assembly.
Install the cable to the intermediate cable connector.
Release and remove the lock out device.
Perform the park brake adjustment procedure. Refer to TENSIONER, PARKING BRAKE CABLE, ADJUSTMENTS .
Remove the supports and lower the vehicle.