Front Parking Brake Cable
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - PARK BRAKE PEDAL |
| 2 - FRONT CABLE |
- From inside the vehicle, insert the cable end fitting (2) into the hole in the pedal assembly (1).
- Seat the cable retainer in the pedal assembly (1).
- Engage the cable ball end in clevis on the pedal assembly.
- Route the cable through the floorpan and install the body grommet.
- Place the carpet down and install the left cowl trim and sill plate.
- Raise and support the vehicle.
- Route the cable through the underbody bracket and seat the cable end fitting in the bracket.
- Connect the cable to the cable connector.
- Perform the park brake adjustment procedure. Refer to TENSIONER, PARKING BRAKE CABLE, ADJUSTMENTS .
- Lower the vehicle.