LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Base Brakes (Service Information) - 2500 Hd & 3500 Hd) >> Hydraulic/Mechanical >> Tubes And Hoses, Brake >> Removal >> Rear Brake Hose - Heavy Duty (Hd)

Rear Brake Hose - Heavy Duty (Hd)

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Speed Sensor, Mounting Bolt & Sensor Wire Harness
GC0108024Courtesy of CHRYSLER GROUP, LLC
  1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
  2. Raise and support the vehicle.
  3. Remove the brake line (2) located at the axle.
    Fig 2: Mounting Bolt, Banjo Bolt & Brake Hose
    GC0108025Courtesy of CHRYSLER GROUP, LLC
  4. Remove the mounting bolt (4) for the brake hose (3) at the axle.
  5. Remove the banjo bolt (2) at the caliper.
  6. Remove the hose (3).
scientia non olet · About LEMON Manuals