Pedal Assembly
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The brake pedal is serviced as a complete assembly including accelerator pedal and the bracket.
NOTE:
The views in this procedure are with adjustable pedals. Without adjustable pedals are similar.
- Disconnect the negative battery cable.
- Remove the brake lamp switch. Refer to SWITCH, STOP LAMP, REMOVAL
.NOTE:
Do not discard the stop lamp switch as it can be adjusted and reinstalled.
- Remove the steering column. Refer to COLUMN, REMOVAL .
- Disconnect the electrical connectors.
- Remove the brake booster rod to brake pedal retainer clip and discard the clip.
- Remove the four brake booster nuts.
- If equipped with a manual transmission, remove the clutch master cylinder to clutch pedal clip and pin.NOTE:
If equipped with an automatic transmission a clutch master cylinder block out plate is used in place of the master cylinder and the retaining nuts will still be used.
- Remove the two clutch master cylinder nuts.
- Remove the three pedal assembly mounting bolts (to instrument panel) and remove the pedal assembly (4) from the vehicle.