LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Base Brakes (Service Information) - 2500 Hd & 3500 Hd) >> Hydraulic/Mechanical >> Master Cylinder, Brake >> Installation >> HYDROBOOST

Master Cylinder, Brake: Installation: HYDROBOOST

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Wiring Box, Mounting Nut & Master Cylinder
GC0108003Courtesy of CHRYSLER GROUP, LLC
NOTE:

If master cylinder is replaced bleed cylinder before installation.

  1. Install the master cylinder (4) on the booster mounting studs.
  2. Install a new upper mounting nut (2) and tighten to 25 N.m (221 in. lbs.).
  3. Reinstall the wiring box (3) back into position and reclip.
    Fig 2: Identifying Nut, Electrical Connector, Brake Lines & Master Cylinder
    GC0108000Courtesy of CHRYSLER GROUP, LLC
  4. Install a new lower mounting nut (4) and tighten to 25 N.m (221 in. lbs.).
  5. Install the brake lines (5) and tighten to 26 N.m (230 in. lbs.)
  6. Reconnect the electrical connector (1) for the low fluid level switch.
  7. Fill and bleed the base brake system. Refer to STANDARD PROCEDURE  .
scientia non olet · About LEMON Manuals