LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Base Brakes (Service Information) - 2500 Hd & 3500 Hd) >> Hydraulic/Mechanical >> Junction Block, Brake Tube >> Installation >> Rear Junction Block

Rear Junction Block

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Junction Block, Brake Lines, Clips & Bolts
GC0087330Courtesy of CHRYSLER GROUP, LLC
  1. Position the junction block (2) on the frame.
  2. Install the junction block mounting bolt (5) and tighten to 24 N.m (18 ft. lbs.).
  3. Install the brake lines (1, 3, 4, 6) into the junction block (2) and tighten to 19 N.m (169 in. lbs.).
  4. Remove the supports and lower the vehicle.
  5. Remove the prop rod and bleed the base brake system. Refer to STANDARD PROCEDURE  .
scientia non olet · About LEMON Manuals