LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Base Brakes (Service Information) - 2500 Hd & 3500 Hd) >> Hydraulic/Mechanical >> Caliper, Disc Brake >> Installation >> Front - Heavy Duty

Front - Heavy Duty

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Install a new copper washers on the banjo bolt when installing

  1. Install the disc brake caliper.
    CAUTION:

    Verify that the brake hose is not twisted or kinked before tightening the fitting bolt.

  2. Install the banjo bolt with new copper washers to the caliper. Tighten to 27 N.m (20 ft. lbs.)
  3. Install the caliper slide pin bolts. tighten to 32 N.m (24 ft. lbs.)
  4. Remove the prop rod from the brake pedal.
  5. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.  . Refer to STANDARD PROCEDURE  .
  6. Install the tire and wheel assembly. Refer to SPECIFICATIONS .
  7. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals