Standard Stabilizer Bar

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All views are typical.

Fig 1: Identifying Retainer, Grommet, Stabilizer Bar, Axle Bracket & Stabilizer Link

Courtesy of CHRYSLER GROUP, LLC

1 - RETAINER

2 - GROMMET

3 - STABILIZER BAR

4 - AXLE BRACKET

5 - STABILIZER LINK

Position the stabilizer bar on the frame rail and install the clamps and bolts. Ensure the bar is centered with equal spacing on both sides.
Tighten the clamp bolts to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
Install links (5), retainers (1), grommets (2) and nuts to the stabilizer bar (3). Hold the link shaft with a wrench and tighten the nuts to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
Remove the supports and lower the vehicle.