LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Front Suspension & Wheel Alignment - 2500 Hd & 3500 Hd) >> Front, Link And Coil >> Hub And Bearing >> Removal >> 4500 And 5500

4500 And 5500

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
  3. Remove the brake caliper. Refer to CALIPER, DISC BRAKE, REMOVAL .
  4. Remove the caliper adapter. Refer to ADAPTER, DISC BRAKE CALIPER, REMOVAL .
    Fig 1: Disc Brake Rotor, Hub Extension & Axle Shaft Nut
    GC0107539Courtesy of CHRYSLER GROUP, LLC
  5. Remove the hub extension (2) and disc brake rotor (1). Refer to ROTOR, BRAKE, REMOVAL .
  6. Remove the axle shaft nut (3) from the axle shaft.
    Fig 2: Identifying Wheel Speed Sensor And Mounting Bolt
    GC0107540Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the wheel speed sensor wire and remove the wheel speed sensor bolt (1) from the hub/bearing then remove the sensor (2).
    Fig 3: Hub/Bearing Bolts
    GC0107541Courtesy of CHRYSLER GROUP, LLC
  8. Loosen the hub/bearing 4 mounting bolts (1).
    Fig 4: Special Tool, Pry Bar & Hub/Bearing Mounting Bolt
    GC0155200Courtesy of CHRYSLER GROUP, LLC
  9. Using (special tool #10415, Remover, Front Hub) and a pry bar (2), place the tool (1) onto the hub/bearing mounting bolts to separate the hub/bearing from the knuckle assembly.
  10. Remove the hub/bearing 4 mounting bolts (1) and remove the hub/bearing.
scientia non olet · About LEMON Manuals