LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Front Suspension & Wheel Alignment - 2500 Hd & 3500 Hd) >> Front, Link And Coil >> Arm, Upper Control >> Installation >> Right

Arm, Upper Control: Installation: Right

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Arm Bolt
GC0107521Courtesy of CHRYSLER GROUP, LLC
NOTE:

Discard the nuts and bolts and do not reuse. New nuts and bolts should be used when replacing or servicing the control arms.

  1. Position the upper control arm (2) at the axle and frame rail.
  2. Install the bolts, then finger tighten the nuts (1).
  3. Tighten nut at the axle bracket and frame bracket to specifications. Refer to FRONT, LINK AND COIL, SPECIFICATIONS .
  4. Remove the support for the axle.
    Fig 2: Exhaust System
    GC0107520Courtesy of CHRYSLER GROUP, LLC
  5. Install the exhaust system back into place.
  6. Reconnect the rubber exhaust mounts.
  7. Reconnect the exhaust (2) at the manifold(s) (1).
  8. Reconnect the exhaust bracket (4) at the transmission.
  9. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals