Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE WIRING AND CONNECTORS
1. Using the schematics as a guide, check the Powertrain Control Module (PCM) terminals for corrosion, damage or terminal push out. Pay particular attention to all power and ground circuits.
2. Wiggle the wires while checking for shorted and open circuits.
3. Check Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair the power and/or ground circuits as necessary.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the PCM in accordance with the Service Information. With the scan tool, perform a Quick Learn. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to STANDARD PROCEDURE .