Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

PROGRAM THE POWERTRAIN CONTROL MODULE
NOTE:
Diagnose any Engine Coolant Temperature Sensor DTCs before continuing.
1. Verify the PCM is at the latest calibration (flash level).
  NOTE:
  An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.
2. Program the PCM in accordance with the Service Information. Refer to STANDARD PROCEDURE and follow the PCM/ECM PROGRAMMING procedure .
3. Start the engine.
4. Allow the engine to reach normal operating temperature.
5. Operate the accelerator pedal. (do not exceed 3500 rpm).
6. With the scan tool, select View DTCs.
  NOTE:
  Diagnose any other DTCs that may have set with the P060F.
  
  Does this DTC reset by itself?
  
  Yes
  - Replace and reprogram the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test Complete.