LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 323 (3.6L - DTCS P018D To PO571 - 1500) >> Diagnosis And Testing >> P054C-Camshaft Position Timing Over - Advanced - Bank 2 >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR CURRENT DTC 
    1. Turn the ignition on.
    2. With the scan tool, read PCM DTCs.

      Are any other DTCs present?

      Yes 

      • Diagnose any other Camshaft Position Sensor DTCs before continuing.

      No 

      • Go To  2
  2. INTERMITTENT WIRING AND CONNECTORS 
    1. The conditions necessary to set this DTC are not present at this time.
      NOTE:

      Check connectors - Clean/repair as necessary. Poor pin to terminal connections can set DTCs.

      Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the wires while checking for shorts and open circuits.

      NOTE:

      Check for any Technical Service Bulletins that may apply.

      Were there any problems found?

      Yes 

      • Repair as necessary.
      • Perform POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible intermittent condition.
scientia non olet · About LEMON Manuals