LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 323 (3.6L - DTCS P018D To PO571 - 1500) >> Diagnosis And Testing >> P0390-Camshaft Position Sensor Circuit - Bank 2 Sensor 2 >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

At least five seconds or 2.5 engine revolutions have elapsed with Crankshaft Position Sensor signals present but no camshaft position sensor signal. One Trip Fault. Three good trips to turn off the MIL. If the vehicle is equipped with the stop/start feature, the system will be disabled when this DTC is active. 

scientia non olet · About LEMON Manuals