LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (8HP70 Automatic Transmission (Service Information0 1500) >> Cable, Manual Park Release >> Removal >> Removal

Cable, Manual Park Release: Removal: Removal

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle

    Refer to HOISTING, STANDARD PROCEDURE .

    Fig 1: Manual Park Release Cable, Lever & Bracket
    GC0154444Courtesy of CHRYSLER GROUP, LLC
  2. Remove the cable (1) from ball stud (2) on the Mechanical Park Release (MPR) lever.
    Fig 2: Left Side Transmission Line Bracket Bolt
    GC0154470Courtesy of CHRYSLER GROUP, LLC
  3. Release the clip at the MPR bracket and pull the cable through the bracket.
  4. Release the clip holding the cable to the trans case.
  5. Remove the cable from the frame bracket.
  6. Lower the vehicle.
    Fig 3: MPR Cover
    GC0154478Courtesy of CHRYSLER GROUP, LLC
  7. Remove the MPR cover (1).
    Fig 4: MPR Lever
    GC0154637Courtesy of CHRYSLER GROUP, LLC
  8. Remove the left side screw at the lever (1).
  9. Loosen the right side screw, but do not remove.
  10. Remove the MPR through the backside of the instrument panel.
  11. Remove the grommet, and pull the MPR cable through the bulkhead.
scientia non olet · About LEMON Manuals