Solenoid, Evaporative Emissions Purge: Removal: 4.7L/5.7L
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
The duty cycle EVAP canister purge solenoid (1) is located in the engine compartment below and near the battery.
- Carefully pull the solenoid assembly straight up from the tongue-type bracket without bending the two vapor lines.
- Disconnect electrical wiring connector (2) at solenoid.
- Disconnect vapor line quick-connect fitting (3) at solenoid.
- Disconnect vapor line quick-connect fitting (4) at solenoid.