Solenoid, Evaporative Emissions Purge: Removal: 3.6L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: EVAP Canister Purge Solenoid & Electrical Connectors

Courtesy of CHRYSLER GROUP, LLC

The duty cycle EVAP canister purge solenoid (2) is located in the engine compartment mounted on the intake manifold.

Carefully pull the solenoid assembly straight up from the tongue-type bracket without bending the two vapor lines.
Disconnect electrical wiring connector (3) at solenoid.
Disconnect vapor line quick-connect fitting (1) at solenoid.
Disconnect vapor line at the solenoid.