LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Steering System) >> Linkage, Link and Coil >> DAMPER, Steering, Link and Coil >> Removal >> Bracket

DAMPER, Steering, Link and Coil: Removal: Bracket

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

All views are typical.

Fig 1: Identifying Steering Damper & Linkage Bracket Bolt
GC0137167Courtesy of CHRYSLER LLC
  1. Raise and support the vehicle. Refer to Hoisting , Standard Procedure .
  2. Remove the steering damper mounting nut (6) at the linkage bracket (3) and position the steering damper (1) off the retaining bolt (7).
    3. NOTE:

    Some vehicles may have only one u-bolt retaining the bracket to the tie rod.

  3. Remove the four (or two) mounting bracket u-bolt nuts (5) and remove the bracket (3).
scientia non olet · About LEMON Manuals