LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Steering System) >> Diagnosis and Testing >> Power Steering Flow And Pressure >> Gas Engine Tool Connections

Gas Engine Tool Connections

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Analyzer Setup To Test AT Pump
GC0080505Courtesy of CHRYSLER LLC
  1. Connect Hose Assembly (special tool #6959, Assembly, Hose) (1) to the valve side of Power Steering Analyzer (special tool #6800, Analyzer, Power Steering) (3), and connect Adapter (special tool #6826, Adapter, LH P/S Tester) (2) to the hose assembly.
  2. Connect Power Steering Hose (special tool #6713, Hose, Power Steering) (6) to the gauge side of Power Steering Analyzer (special tool #6800, Analyzer, Power Steering) (3), and connect P/S Adapter (special tool #6825A, Adapter, Power Steering) or (special tool #6865, Adapter, Power Steering (Jeep)) (as necessary for clearance) to the hose assembly.
  3. disconnect the P/S pump pressure line at the P/S pump.
  4. Connect the hose from the valve side of the Power Steering Analyzer (special tool #6800, Analyzer, Power Steering) (3) to the pressure line at the P/S pump.
  5. Connect the hose from the gauge side of the Power Steering Analyzer (special tool #6800, Analyzer, Power Steering) (3) to the P/S pump.
  6. Proceed with the Flow and Pressure Test below.
scientia non olet · About LEMON Manuals