LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Steering System) >> Column >> LEVER, Gearshift >> Installation >> Lever Only

Lever Only

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Gearshift Lever Assembly (2)
GC0088327Courtesy of CHRYSLER LLC
  1. Install the gearshift lever (1) in the gearshift lever assembly (2).
  2. Install the gearshift lever pinch bolt (7) and tighten to 12 N.m (105 in. lbs.).
  3. Connect the gearshift harness retainers (6).
  4. Connect the gearshift harness connector (5).
  5. Install the upper and lower column shrouds, steering column opening cover, and reinforcement. Refer to SHROUD, Steering Column , Installation .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals