LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 294 (65RFE Automatic Transmission (Service Information) 1500) >> Sensor, Speed, Input >> Removal >> Removal

Sensor, Speed, Input: Removal: Removal

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input, Output, & Line Pressure Sensors
GC0082969Courtesy of CHRYSLER GROUP, LLC
1 - OUTPUT SPEED SENSOR
2 - LINE PRESSURE SENSOR
3 - INPUT SPEED SENSOR
  1. Raise vehicle.
  2. Place a suitable fluid catch pan under the transmission.
  3. Remove the wiring connector from the input speed sensor (3).
  4. Remove the bolt holding the input speed sensor to the transmission case.
  5. Remove the input speed sensor (3) from the transmission case.
scientia non olet · About LEMON Manuals