LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (Tires & Wheels (Service Information) 1500) >> Wheels >> Stud, Wheel >> Removal >> Rear - 1500 Only

Rear - 1500 Only

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: C-4150A Positioned For Stud Removal
GC0080593Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Move axle shaft carefully to prevent damage to the shaft bearing and seal in the axle tube.

  1. Pull the axle shaft out of the axle approximately 25mm (1 in.) for clearance to remove the wheel stud, refer to SHAFT, AXLE .
  2. Press the stud (1) from the hub using Ball Joint Press (special tool #C-4150A, Press, Ball Joint) (3).
  3. Remove the stud (1) from the rear of the hub flange.
scientia non olet · About LEMON Manuals