Pipe, Exhaust: Installation: 3.6L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Y-Pipe Flange Nuts

Courtesy of CHRYSLER GROUP, LLC

Position the exhaust Y-pipe (1) with proper clearance between the frame and underbody parts. A minimum clearance of 25 mm (1.0 in.) is required.
Position the Y-pipe to the catalytic convertor down pipes. Tighten the nuts (2) to 30 N.m (22 ft. lbs.).

Fig 2: Exhaust System - 3.6L Engine - Typical
Courtesy of CHRYSLER GROUP, LLC
Align the exhaust pipe (1) to the Y-pipe (3). Tighten the nuts (2) to 30 N.m (22 ft. lbs.).
Lower the vehicle.
Start the engine and inspect for exhaust leaks and exhaust system contact with the body panels. Adjust the alignment, if needed. Refer to DIAGNOSIS AND TESTING .