Sensor, Coolant Temperature: Installation: 4.7L
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ECT SENSOR |
| 2 - MOUNTING BOLTS (2) |
| 3 - MAP SENSOR |
| 4 - INTAKE MANIFOLD |
- Apply thread sealant to ECT sensor threads.
- Install ECT sensor (1) to engine.
- Tighten ECT sensor to 11 N.m (8 ft. lbs.).
- Connect electrical connector to ECT sensor (1).
- Replace any lost engine coolant. Refer to STANDARD PROCEDURE .