Belt, Serpentine: Installation: 5.7L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Belt Routing (5.7L Engine)

Courtesy of CHRYSLER GROUP, LLC

NOTE:

When installing accessory drive belt onto pulleys, make sure that belt is properly routed and all V-grooves make proper contact with pulleys.

Position the accessory drive belt (3) over all pulleys (1, 2, 4, 5, 6) except for the water pump pulley (7).
Rotate the tensioner (4) clockwise and slip the belt over the water pump pulley (7).
Gently release the tensioner.

CAUTION:

Do not let the tensioner arm snap back to the freearm position, severe damage may occur to the tensioner.