Throttle Body: Installation: 3.6L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Body-To-Intake Manifold Seal

Courtesy of CHRYSLER GROUP, LLC

Check the condition of the throttle body-to-intake manifold seal (1). The seal can be reused if not damaged.
Clean the mating surfaces of the throttle body and intake manifold.

Fig 2: Throttle Body, Bolts & Connector
Courtesy of CHRYSLER GROUP, LLC
Position the throttle body (1) to the intake manifold.
Install the four throttle body mounting bolts (4) and tighten in a criss-cross pattern sequence to 7 N.m (62 in. lbs.).
Connect the electrical connector (3) to the Electronic Throttle Control (ETC) (1) and secure the ETC harness to the clip (2) on the throttle body.

Fig 3: IAT Sensor Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Install the air intake resonator assembly. Refer to RESONATOR, AIR CLEANER, INSTALLATION .
Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).