Sensor, Oxygen: Installation: 4.7L/5.7L
WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
5.7L system shown in the illustration. 4.7L similar.
Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal.DO NOT add any additional anti-seize compound to threads of a new oxygen sensor.
- Install O2 sensor. Tighten to 41 N.m (30 ft. lbs.).
- Connect O2 sensor wire connector.
- Lower vehicle.