Sensor, Crankshaft Position: Removal: 3.6L

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: CKP Sensor - 3.6L

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Disconnect the electrical connector (3) from the crankshaft position (CKP) sensor.

Fig 2: Sensor Mounting Bolt & Sensor
Courtesy of CHRYSLER GROUP, LLC
Remove the sensor mounting bolt (2).
Carefully twist the sensor (1) from the cylinder block.

Fig 3: O-Ring
Courtesy of CHRYSLER GROUP, LLC
The CKP sensor O-ring (1) can be reused if not damaged.